Télécharger Imprimer la page

Ryobi ONE+ P326 Manuel D'utilisation page 9

Calibre 16, cloueuse de finition droite de 18 v

Publicité

Les langues disponibles

Les langues disponibles

 Reinstall battery, and reactivate nailer by pressing the
LED worklight grip switch.
WARNING:
Use only the nails recommended for use with this tool.
The use of any other nails can result in tool malfunction,
leading to serious injuries.
WARNING:
Never load nails with the workpiece contact or trigger
activated. Doing so could result in possible serious
personal injury.
SETTING THE AIR PRESSURE
See Figure 6, page 13.
The amount of air pressure required will depend on the size
of the nail and the workpiece material.
Begin testing the depth of drive by driving a test nail into
the same type of workpiece material used for the actual job.
 Remove battery pack from the tool, if installed.
 Move air pressure lever to the right to increase air pressure
or to the left to decrease pressure.
It may be possible to achieve the desired depth with air
pressure adjustments alone. If finer adjustments are needed,
use the depth of drive adjustment on the tool.
NOTE: Under some conditions, the unit may not deliver a
nail when the air pressure lever is moved to the MAXIMUM
pressure setting. The user may need to decrease the pressure
setting for desired operation.
DEPTH OF DRIVE ADJUSTMENT
See Figure 7, page 13.
The driving depth of the nail may be adjusted beyond air
pressure. It is advisable to test the depth on a scrap workpiece
to determine the required depth for the application.
To determine depth of drive, first adjust the air pressure and
drive a test nail. To achieve the desired depth, use the depth
of drive adjustment on the tool. Harder materials and longer
nails will require more force to drive the nail.
 Remove battery pack from the tool, if installed.
 Turn the depth of drive adjustment left or right to change
the driving depth.
 Reinstall battery and reactivate the tool by pressing the
worklight grip switch.
 Drive a test nail after each adjustment until the desired
depth is set.
NOTE: Set depth of drive at the shallowest depth that
will meet your needs.
OPERATION
DRIVING FINISH NAILS
See Figure 8 , page 13.
WARNING:
Never wedge or hold back the workpiece contact
mechanism during operation of the tool. Doing so could
result in possible serious injury.
Single sequential actuation mode:
Single sequential actuation provides the most accurate
fastener placement.
 Reinstall battery and reactivate the tool by pressing the
worklight grip switch.
 Grip the tool firmly to maintain control. Position the nose
of the tool onto the work surface.
 Push the tool against the work surface to depress the
workpiece contact.
 Squeeze the trigger to drive a fastener.
NOTE: Hold trigger until drive cycle is complete. If depressing
the trigger does not drive a fastener, lift the tool away from
the workpiece, then replace and try driving the fastener again.
DRY-FIRE LOCKOUT
When the magazine has 0-5 nails remaining, the dry-fire
lockout feature will not allow continued operation.
To resume operation, reload the tool with nails.
LED WORKLIGHT
See Figure 9, page 13.
Press LED worklight grip switch while firmly holding tool
during operation.
DIAGNOSTIC FEEDBACK
The LED Worklight provides feedback to indicate whether
the battery pack is charged sufficiently and/or if the tool is
functioning properly.
If worklight is flashing, install fully charged battery. If light
continues to flash, see Troubleshooting section for more
information.
If the LED light goes out on your nailer, the unit has timed
out for your protection. Lift tool from the workpiece and
release trigger to reactivate the nailer before beginning next
drive cycle.
9 — English

Publicité

loading