Kohler STERLING 7104 Serie Guide D'installation Et D'entretien page 18

Coloque la bañera (cont.)
Limpie la bañera para reducir el riesgo de daños a la superficie.
Coloque una lona limpia u otro material similar en el fondo y sobre el filo exterior
de la bañera. Tenga cuidado de no rayar la superficie de la unidad.
5.
Secure the Bath
Bath Flange
Bride de la baignoire
Reborde de la bañera
NOTE: To avoid damaging the finish of the bath, make sure that there is a drop cloth
or other protective liner in the bath before proceeding.
Secure the Bath
NOTE: Attach the bath using the support clips (provided). Refer to the "Roughing-In"
section for proper placement.
Install roofing nails or flathead screws through the apron extension side tabs into
the studs.
Verify the studs are within 1/8" (3 mm) of the bath at the recommended support
clip or screw locations. Shim if necessary.
At the side of the stud, position the bottom lip of the support clip under the
flange of the bath, as shown.
Slide the support clip into place between the center of the stud and the bath.
Using a pliers, bend the tab of the support clip over the bath flange.
Repeat these steps for the remaining support clips.
Secure the support clips to the studs with truss head screws.
1064912-2-C
Stud/Montant/Poste de madera
Nail
Clou
Clavo
Attachment Clip
Clip d'attache
Clip de sujeción
Bath/Baignoire/Bañera
18 Sterling