Publicité
Les langues disponibles
Les langues disponibles
1. Completely remove the support bar. Place the support bar's anchor (D) back on its wall mark, then mark its center
on the wall.
2-3. Drill a hole on the center marks with a ø8mm (5/16in) drill bit and insert the wall anchors (FF) using a rubber
mallet. Fix the center fitting on the support bar's anchor (D) using the screws (HH).
4 Slide again the auxiliary roller (E), 2 fixed panel's brackets (G) and the support bar's anchor (D) onto the support bar
(F). Then fix the support bar to fixed panel (C) by the 2 fixed panel's brackets (G).
5. Fix the support bar's anchor (D) to wall.
1
D
3
D
HH
5
D
SUPPORT BAR INSTALLATION
FF
13
2
Φ 8mm
5/16in
4
G
KK
C
Publicité
