peerless-AV SC550 Installation Et Assemblage page 9

For Flat Back Display
6-1
Begin with the shortest length screw, hand thread screw through multi-washer and display brackets (B) into
display as shown. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not
overtighten. If screw cannot make three full turns into the display, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level display brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of display.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
For Bump-out or Recessed Back Display
6-2
Begin with the longest length screw, hand thread screw through multi-washer, display brackets (B) and spacer in
that order into display as shown. Screw must make at least three full turns into the mounting hole and fi t snug into
place. Do not overtighten. If screw cannot make three full turns into the display, select a shorter length screw from
the baffl ed fastener pack. Repeat for remaining mounting holes, level display brackets and tighten screws.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
DISPLAY
DISPLAY
SPACER (HH)
9 of 35
MULTI-WASHER (GG)
SCREW
(AA,CC,EE)
UNIVERSAL ADAPTER
PLATE (B)
MULTI-WASHER (GG)
SCREW
(BB,DD,FF)
UNIVERSAL ADAPTER
PLATE (B)
ISSUED: 02-25-11 SHEET #: 009-9048-4 06-16-14