Electrolux ERB29003W1 Notice D'utilisation page 26

26 electrolux
m1
m5
m3
2. Remove the doors.
3. Remove the spacer (m6) and move to
the other side of the hinge pivot (m5).
4. Remove using a tool the cover (b1). Un-
screw the lower hinge pivot (b2) and the
spacer (b3) and place them on the op-
posite side.
5. Re-insert the cover (b1) on the opposite
side.
6. Remove the stoppers (1) and move to
the other side of the doors.
m2
m6
m4
b1
b2
b3
1
7. Unscrew the upper hinge pivot (t1) and
screw it on the opposite side.
8. Remove the left-hand cover pin of the
middle hinge (m3,m4) and move to the
other side.
9. Fit the pin of the middle hinge (m5) into
the left-hand hole of the lower door.
10. Re-insert the lower door on the lower
hinge pivot (b2).
11. Fit the upper door on the upper hinge
pivot (t1).
12. Re-insert the upper door on the middle
hinge pivot (m5) slightly tilting both
doors.
13. Re-screw the middle hinge (m2). Do not
forget the plastic spacer (m1) inserted
under the middle hinge. Make sure that
the edges of the doors run parallel to the
side edge of the appliance.
14. Reposition, level the appliance, wait for
at least four hours and then connect it to
the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the cabinet.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Win-
ter), the gasket may not fit perfectly to the