Hitachi Koki Tanaka TBC-225 Mode D'emploi page 10

1. Set ignition switch (15) to ON position. (Fig. 16,
17)
15
Fig. 16
* Push priming bulb (18) several times so that fuel
fl ows through return pipe. (If so equipped) (Fig.
18)
19
18
2. With the safety trigger (16) pressed (if so
equipped), pull throttle trigger and push throttle
lock (17), then slowly release the throttle trigger
fi rst, then the safety trigger. This will lock the
throttle in starting position.
3. Set choke lever to CLOSED position (19). (Fig.
18)
4. Pull recoil starter briskly, taking care to keep the
handle in your grasp and not allowing it to snap
back. (Fig. 19)
5. When you hear the engine want to start, return
choke lever to RUN position (open). Then pull
recoil starter briskly again.
NOTE
If engine does not start, repeat procedures from 2
to 5.
10
151716
Fig. 17
19
Fig. 18
Fig. 19
6. After starting engine, pull throttle trigger to
release throttle lock. Then allow the engine about
2-3 minutes to warm up before subjecting it to
any load.
Cutting (Fig. 20, 21, 22)
○ When cutting, operate engine at over 6500/min.
Extended time of use at low rpm may wear out
the clutch prematurely.
○ Cut grass from right to left.
○ Blade thrust may occur when the spinning blade
contacts a solid object in the critical area.
A dangerous reaction may occur causing the
entire unit and operator to be thrust violently.
This reaction is called blade thrust. As a result,
the operator may lose control of the unit which
may cause serious or fatal injury. Blade thrust is
more likely to occur in areas where it is diffi cult to
see the material to be cut.
Fig. 20
Fig. 21
Fig. 22