Brandy Best WINDOPRO30 Mode D'emploi page 23

Adjusting the reversible door
You will require a flathead screwdriver and a cross-headed screwdriver.
1
Removing the three right hinge fixing screws with a phillips screwdrive.
2
Taking out the right hinge.
3
Removing the three left hinge fixing screws with a phillips screwdriver
4
Taking out the decoration sheet
Cleaning
The mini-bar must be cleaned and maintained at least once a month.
During maintenance, ensure that the appliance is unplugged.
Cleaning the exterior of the mini-bar:
You can use soap to clean the exterior of the appliance. However you should ensure that the door is fully
closed in order to avoid contact between the product and the seal, or with the interior of the mini-bar. You
can also just use a damp cloth.
Cleaning the interior of the mini-bar:
You can clean the interior of your mini-bar with a mild solution of bicarbonate of soda. After, rinse with hot
water using a wrung cloth. Then wipe in order to remove any trace of moisture.
Pay attention to the maintenance of the rubber door seals. They must always be clean in order to avoid
mould.
NOTE: Do not use diluents, petrol, alcohol, kerosene, abrasive detergents, washing powder, acid, chemical
products, etc. in order to avoid damaging the plastic. It is discouraged to spray water directly onto the mi-
ni-bar. This could cause rusting.
5
Inserting the decoration sheet inside the right hinge slot.
6
Fixing the decoration sheet by screwing the right three screws.
7
Insert the left door hinge (it's packed with the user manual )
8
Fixing the left hinge by screwing the three screws,then the interchange is finished.
Page 9