Glatz Suncomfort Pop Up Notice D'instructions page 20

Use
Slider
Tilting device
with lock
Upper pole
Lower pole
1
Ribs
Ribbons
Cover
Clamping screw
Base
(optional)
Open sunshade
Remove the protective cover, if present
1. Loosen the ribbons
2. Pull the ribs outwards slightly
3. Slide the slider upwards
38 39
2
Adjust the sunshade height
When adjusting the sunshade height,
keep a firm hold on the upper pole,
to prevent it lowering accidentally.
1. Hold upper pole firmly
2. Loosen clamping screw
3. Adjust sunshade height to suit
4. Tighten the clamping screw
3
Tilt the sunshade canopy
When tilting the sunshade, hold the
moving part on the upper pole firmly.
1. Hold moving part firmly
2. Push in the lock on the tilting device
completely
3. Tilt sunshade (possible on both
sides)
4
Close sunshade
1. Sunshade canopy in an upright position
2. Pull the slider downwards
3. Pull out / wrap fabric segments
4. Tie the ribbons
!
The lock of the tilting device must
audibly engage when putting the
sunshade in upright position!