Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Proper Hand Position (Fig. A, D)
WARNING: To reduce the risk of serious personal
injury, ALWAYS use proper hand position as shown.
Use only one hand to hold the tool as shown in Figure C. Do
not place your other hand over the air vents
Fig. D
Prior to Operation (Fig. A)
WARNING: Make sure the nozzle always points away
from you and any bystanders.
WARNING: DO NOT drop anything into the nozzle.
WARNING: DO NOT exceed 60 minutes "ON" in a
2 hour period.
1. Attach the correct accessory recommended for
the application.
2. Slide the air temperature adjustment switch
desired air temperature.
Switching On and Off (Fig. A, E)
1. Push the air temperature adjustment switch
desired air flow settings:
2. A low air flow to heat up the workpiece slowly.
I
3.85 CFM [550˚F (288 ° C)]
A high air flow to heat up the workpiece quickly.
II
6.7 CFM [990˚F (532˚C)]
3. To power on: flip trigger switch
the trigger
1
. To keep the unit on hands free then, press
in the lock-on button
4. To turn the unit off release the trigger. If the trigger is
locked -on, squeeze the trigger slightly to disengage the
lock-off button and then release the trigger.
nOTE: Disconnect the tool from the power source and let
the tool cool down before moving or storing it.
nOTE: When using hands free operation ensure that
the heat gun is placed in such a way that it will not tip
over. Place the heat gun in a location where it will not
be inadvertently knocked over and is free of flammable
materials. If the product is bumped or placed poorly it could
fall and burn or ignite materials in the area.
.
2
3
3
10
upwards and pull in
8
on the left with your thumb.
Fig. E
10
1
Removing Paint (Fig. A)
WARNING: Refer to Important Notice under
Additional safety information before using the
tool to remove paint.
WARNING: Do not strip metal window frames as the
heat may crack the glass.
•
•
•
1. Attach the appropriate accessory.
to
2. Slide the air temperature adjustment switch
3. To power on: flip trigger switch
the trigger
4. Direct the hot air onto the paint to be removed.
to the
Best results will be achieved if the heat gun is moved
slowly, but CONSTANTLY, from side to side to evenly
distribute heat. DO NOT LINGER OR PAUSE IN ONE SPOT.
5. When the paint softens, scrape the paint away using a
hand scraper.
REMEMBER: Splinters and small particles of stripped paint
can be ignited and blown through holes and cracks in the
surface being stripped.
Stationary Use (Fig. F)
This tool can also be used in stationary mode.
1. Set the tool onto a level, stable workbench. Ensure the
tool will not tip over.
2. Turn the tool on by selecting the desired air flow.
When striping other window frames, use a glass
protection nozzle.
To prevent igniting the surface, do not keep the
tool directed at one spot too long.
Avoid collecting paint on the scraper accessory, as
it may ignite. If necessary, carefully remove paint
debris from the scraper accessory using a knife.
10
1
.
English
8
to high.
3
upwards and pull in
9
Publicité
Table des Matières
