Télécharger Imprimer la page

Avigilon 1.0-H3-DO1-IR Guide D'installation page 14

Caméra dôme ip h.264 haute définition

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 30
Removing the Dome Cover
Remove the dome cover by loosening the tamper-proof screws that fix
the cover to the base. The tamper resistant key included with the
dome camera can be used to loosen the screws.
NOTE: Be careful not to scratch or touch the dome bubble. The
resulting marks or fingerprints may affect the overall image
quality. Try not to touch the dome bubble and keep the
protective cover on the bubble until after the installation is
complete.
Mounting the Dome Camera
Caution — The dome camera must be mounted as
instructed below or problems with moisture may arise and
will not be covered by the dome camera warranty.
Perform the following steps to mount the dome camera to a ceiling or
wall:
1.
Determine where the cables will enter the camera. The
camera has two cable entry holes: one on the side and
one on the bottom of the dome camera.
a.
b.
2.
Attach a conduit connector to the cable entry hole. Install
the conduit and its fitting as instructed by the
manufacturer.
NOTE: Only vandal resistant conduits should be used to protect
the cables, and be compatible with the dome camera's
vandal resistant design.
6
Use the supplied 1/2" NPT closure plug to fill the
unused cable entry hole.
When installing outdoors, wrap the thread of the
plug with the supplied Teflon sealing tape to create
a water tight seal.

Publicité

loading