Installation
Fig. C
Tabletop Charging Base Installation (FBS012NBC-XX only)
1.
Slide the speaker into the charging base until securely attached onto
the charging base as shown below. Do not installed inversed. (Fig. E)
2.
Turnover the speaker with the bottom of the charging base facing up
and install 4 rubber feet onto the charging base as shown. (Fig. F)
Fig. E
9
Fig. D
Fig. F
CCD-0005526 REV. 11.29.2022
Before Using
Charging your Speaker
Before using the speaker, you must charge the device for a minimum of
5 hours using Micro USB Charing Port or 3.5 hours (minimum) using the
charging base. You may check the power level by short pressing the
button before operating your speaker each time. The power indicator will
be illuminated in white for 3 seconds to show the current power level and
then disappear.
5 Light: 80%-100%
–
4 Light: 60%-80%
–
3 Light: 40%-60%
–
2 Light: 20%-40%
–
1 Light: 0-20%
–
It is recommended you fully charge the battery before using for the first
time. The speaker can be charged in three ways:
● If a genuine Furrion charging base is installed, place the speaker
into the charging base to charge. The speaker will be fully charged in
approximately 3.5 hours.
● Lift to open the rubber cap at the end of the speaker. Connect one end
of the adapter to the Micro USB Port on the speaker and the other end
to a 5V DC outlet. The speaker will be fully charged in approximately
5 hours.