Schumacher Electric SPI6 Traduction De La Notice Originale page 11

PROBLEM
Green LED is flashing and
the display shows CHARGE
ABORTED-BAD BATTERY.
The display shows
CONNECT CLAMPS.
18. SPECIFICATIONS
Input .................................................................................................. 230V AC~50Hz, 1.2A
Output ................................................................................................................. 12V
Ingress Protection rating ..............................................................................................IP20
19. REPLACEMENT PARTS
Battery clamps (quick-connect)..................................................................... 3899002636Z
Ring connectors (quick-connect) ................................................................. 2299002042Z
20. LIMITED WARRANTY
WARRANTY TERMS AND CONDITIONS
Schumacher Electric Corporation (the "Manufacturer") or the resellers authorized by the
Manufacturer (the "Reseller") warrant this Charger (the "Product") according to the following
stipulations. Any and all warranties, other than the warranty included herein, are hereby
expressly disclaimed and excluded to the fullest extent permissible under applicable law.
Legislation may imply warranties or conditions or impose obligations on Manufacturer which
cannot be excluded, restricted or modified in relation to consumer goods.
Consumer End-User Warranty
Any claims under this warranty must be communicated to Reseller within 2 months after
discovery of the non-conformity.
Resellers/Professional End-User Warranty
The Manufacturer provides a limited warranty for hidden defects or non-conformities.
This warranty is subject to the following conditions:
a. The Manufacturer only warrants hidden defects in material or workmanship present
in their root cause at the moment of the first sale by the Manufacturer;
b. Manufacturer's obligation under this warranty is limited to repairing or replacing the
Product with a new or reconditioned unit at the sole option of the Manufacturer;
c. Manufacturer does not have any warranty obligations if the alleged defects were caused
by abnormal usage, fair wear and tear, unauthorized use of the Product or use of the
Product differing from the description in the applicable manual or other specifications
given by the Manufacturer, insufficient care, repairs carried out by persons or entities or
with parts not approved by Manufacturer, poor care, accidents, unauthorized changes
or modifications, incorrect transport, storage or treatment of the Product;
d. In order to exercise this right, the Product must be returned complete and in its original
state and packaging, with mail costs prepaid, along with proof of purchase to the
Manufacturer or its authorized representatives in order for repair or replacement to occur.
POSSIBLE CAUSE
The battery is too large for the
charger.
The battery voltage is still below
10V after 2 hours of charging.
The clamps are not making a good
connection.
The fuse is bad.
• •
11
REASON/SOLUTION
You need a charger with a higher
amp rate.
Have the battery checked.
Check for poor connection at
battery and frame.
Replace the in-line fuse for the ring
connector.
6A