Bear JSQ-F50D2 Manuel D'utilisation page 4

Components and installation drawing
Protruding
point (upwards)
Floating ball of lever
Support
Restricted plug
Floating ball
Protruding point (upwards)
Floating ball of lever
Note: It is needed to insert the
rotary shaft of the floating ball
of lever into the groove vigor-
ously.
Filter element
assembly
Rotary shaft
Groove
Note: Schematics of Installation
in Place.
3
(I) Base installation
1. Put the floating ball into the magnetic ring column (both positive and
negative floating ball are acceptable)
2. Install the restricted plug in place (stuff up)
3. Insert the rotary shaft into the support hold and push it to fix it to the
support and ensure the protruding point of the floating ball of lever
upwards
4. Install the compound filter element assembly right above the water
channel atomizer plate and place it in the middle
5 Insert the fragrance sponge into the fragrance box slot.
(II) Water tank installation:
1. When the water tank is brought back to the base, it is needed to make
the side with LOGO on the water tank and the rotary knob face the same
side.
* The floating ball of level must be installed correctly.
• The water tank base should be kept flat, and the side with LOGO on
the water tank and the rotary knob should face the same side.
• During the service of the machine, it should be placed horizontally.
The side with LOGO
on the water tank
The side with
a rotary knob
4