Miele Powerbrush SEB 234 Mode D'emploi page 13

Why is the Multifunction indicator
light red?
The block protection has been
activated because the roller brush is
blocked by a vacuumed up item.
^ Turn off the vacuum immediately and
unplug it from the outlet.
^ Remove the item.
^ Press the Multifunction indicator. The
reset function resets the block
protection back to the start position.
^ Plug in the vacuum and turn it on.
Frequently asked questions
Why did the powerbrush turn off
automatically?
The thermo protection has been tripped
due to blockage of the vacuum ducts.
^ Turn the powerbrush off using the
foot pedal.
^ Turn off the vacuum and unplug it
from the outlet.
^ Check the vacuum ducts.
^ Turn the vacuum on for approximately
five minutes to allow the vacuum air
to cool the powerbrush down.
^ Turn off the vacuum and unplug it
from the outlet.
Waiting approximately 15 seconds,
then reconnect the vacuum and turn it
on. The powerbrush is ready for
operation.
13