Le Las 227A1 Guide D'instruction page 57

• Programming code Time Silence
*13xx*
Factory setting xx = 00
Example xx = 30
Up to xx = 99
Note: steady frequency tones, whether cadenced or not, are taken as silence.
• Programming code Ring Modulation
*15xx*
Factory setting xx = 00
xx = 01
• Programming code Push Button
*17xx*
Factory setting xx = 00
Up to xx = 98
If xx = 99
DIRECT MEMORY ACCESS BY « R » BUTTON AND DIALLING CHAIN IS ONLY
• Programming code T1: CHAINING MODE
*20xx*
Factory setting xx = 00
Up to xx = 99
Note: during number chaining, there are two options - if T1 is an even number the loudspeaker reproduces
the telephony on the line (dialling-tone, busy, dialling etc...). If T1 is an odd number the loudspeaker
generates a cadenced calming tone and the indicator flashes to the same rhythm.
• Programming code T2: CHAINING MODE
*21xx*
Factory setting xx = 00
Up to xx = 99
Note: during the chaining of numbers in T2, it is the parity of T1 which determines the telephony on the
loudspeaker.
NFC227A*TEL2
\\SERVEUR MAX\\ Notices NFC \ NFC227 TL2 \ NFC227A-TEL2.DOC
All manuals and user guides at all-guides.com
Length of Silence prior to auto-cleardown
The telephone does not clear down on silence
Auto-cleardown after 30 seconds
Auto-cleardown after 99 seconds
Type of ringing modulation
Pure frequency
Mixed frequencies
Continuous time-button M pressed before line taken
Line taken immediately
Action deferred 9.8 seconds
button disabled
A
TTENTION
AVAILABLE IN HAND-FREE MODE
Time in seconds before passing from M1 to M2 to chain
autodialling
No number chaining
99 seconds on M1 before passing to M2
Time in seconds before passing from M2 to M3, M3 to
M4, up to M8 to chain autodial numbers
No number chaining
99 seconds on MX before passing to the next
57 /64