Télécharger Imprimer la page

Audiovox PRESTIGE PLATINUM+ APS-400 Manuel De L'utilisateur page 7

Système de sécurité télécommandé à 3 boutons avec détecteur de vibrations en deux temps
Masquer les pouces Voir aussi pour PRESTIGE PLATINUM+ APS-400:

Publicité

Les langues disponibles

Les langues disponibles

3. Allow the L.E.D. to flash 5 times, and during or immediately after the fifth flash,
quickly turn the ignition key to off, then on, then off, then on.
4. The siren will sound one short chirp, followed by one long chirp, indicating that
the code has been memorized.
5. After a 2 second pause, the L.E.D. will flash 5 times, then pause, then flash 2
times. This confirms that the code 52 has been stored into memory.
USING THE CUSTOM CODE MANUAL OVERRIDE
It is very important that you understand how to operate the manual override feature, as there
may a time that you will need to bypass the alarm when your transmitter is not working. You
should also write down your personalized code number, and keep it in a safe place for future
reference.
To by pass the alarm,
1. Open the door. The alarm will sound.
2. Turn the ignition key to the on position. The alarm will stop for three seconds,
then the siren will begin counting with long chirps.
3. As soon as the chirp that corresponds with your first digit sounds, quickly turn the
ignition key ;
1. off then on if your second digit is 1
2. off then on twice if your second digit is 2
3. off then on three times if your second digit is 3.
4. The alarm will stop sounding, and you can now start the vehicle.
EXAMPLE : To override the system using the example 52 above, you would,
1. Open the door. The alarm will sound.
2. Turn the ignition key to the on position. The alarm will stop for three seconds, then
the siren will begin counting with long chirps.
3. As soon as the fifth chirp has sounded, quickly turn the ignition key off then on then
off then on.
4. The alarm is now disarmed.
IMPORTANT NOTE : If you elect not to program a personalized manual override code, the fac-
tory pre set code is 11. To override the alarm with this code,
1. Open the door. The alarm will sound.
2. Turn the ignition key to the on position. The alarm will stop for three seconds, then
the siren will sound a long chirp.
3. As soon as the chirp has sounded, quickly turn the ignition key off then on.
4. The alarm is now disarmed.
Page 7
128-4633B
7 OF 27

Publicité

loading