Panasonic ER-GC71 Manuel D'instructions page 18

Problem
Charge the clipper.
Or use with the AC operation.
(See pages 11 and 12.)
Charge the battery for
approximately 16 hours
Clipper stopped
continuously to rejuvenate it.
functioning.
If few uses remain even after
charging, the battery has
Operating time
reached the end of its life.
is short.
(Fluid may be leaking due to
degradation at the end of
battery life.)
Contact an authorized service
centre for repair.
Push the appliance plug into
the main body all the way and
make sure the charge indicator
The clipper cannot
lamp (
be charged.
Charge within the
recommended charging
temperature of 0 °C to 35 °C.
Clipper can be
used for only about Have the battery replaced by
10 minutes even an authorized service centre.
after charging.
18
Action
) glows.
Blade life
Blade life varies according to the frequency and period
of use of the clipper.
For example, the blade life is approximately 2 years
when using the clipper for 20 minutes twice a month.
Replace the blades if cutting efficiency reduces
substantially despite proper maintenance.
Battery life
Battery life will vary according to the frequency and
length of use. If the battery is charged once a month,
the service life will be approximately 3 years.
If the operating time is significantly shorter even after a
full charge, the battery has reached the end of its life.
Removing the built-in rechargeable
battery
Remove the built-in rechargeable battery before
disposing of the clipper.
The battery is to be disposed of safely.
Please make sure that the battery is disposed of at an
officially designated location if there is one.