Publicité
Les langues disponibles
Les langues disponibles
• Switch on the tool. Align the intersection point of the laser lines with the
floor marking (10).
• Align the laser beam pointing forward with the wall marking (9).
• Mark the centre of the laser line pointing sideways (11) on the long wall.
• Switch off the tool and rotate it 90° counterclockwise.
• Switch on the tool. Align the intersection point of the laser lines with the
floor marking (10).
• Align the laser beam pointing forward with the wall marking (11).
• Locate the position of the laser beam pointing sideways parallel to the
starting point (8) at the short wall using a target. Mark this point (12) on
the floor. Switch off the tool.
• Measure the difference between the markings (8 & 12).
• If the difference between the markings is 4 mm or less, the tool is
properly calibrated.
• If the difference between the markings is more than 4 mm, the tool must
be serviced.
Cleaning
• Remove the batteries before cleaning the tool.
• Regularly clean the housing and laser apertures with a soft cloth.
• Regularly clean the housing with a soft cloth.
• When necessary, clean the laser apertures using a soft cloth or a cotton
bud soaked in alcohol. Do not use any other cleaning agents.
Separate collection. This product must not be disposed of with
normal household waste.
Should you find one day that your D
if it is of no further use to you, do not dispose of it with household waste.
Make this product available for separate collection.
All manuals and user guides at all-guides.com
WALT product needs replacement, or
E
E N G L I S H
47
Publicité
