Makita JR102D Manuel D'instructions page 5

ENGLISH (Original instructions)
1. Buttons
2. Battery
3. Lock-off button
4. Lock-off lever
5. Switch lever
6. Switch trigger
SPECIFICATIONS
Length of stroke
Strokes per minute (min
Max. cutting capacities
Overall length (with battery)
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for sawing wood, plastic and ferrous
materials.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
CORDLESS RECIPRO SAW
SAFETY WARNINGS
1. Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring. Cutting
accessory contacting a "live" wire may make exposed
metal parts of the power tool "live" and could give the
operator an electric shock.
2. Use clamps or another practical way to secure and
support the workpiece to a stable platform. Holding
the work by hand or against your body leaves it
unstable and may lead to loss of control.
3. Always use safety glasses or goggles. Ordinary
eye or sun glasses are NOT safety glasses.
4. Avoid cutting nails. Inspect workpiece for any
nails and remove them before operation.
5. Do not cut oversize workpiece.
Explanation of general view
7. Lamp
8. Recipro saw blade
9. Blade clamp sleeve
10. Saw blade
11. Hex wrench
12. Bolt
Model
-1
)
Wood
Net weight
JR100D
Pipe
6. Check for the proper clearance beyond the
ENE020-1
workpiece before cutting so that the blade will not
strike the floor, workbench, etc.
7. Hold the tool firmly.
8. Make sure the blade is not contacting the
workpiece before the switch is turned on.
GEA010-1
9. Keep hands away from moving parts.
10. Do not leave the tool running. Operate the tool
only when hand-held.
11. Always switch off and wait for the blade to come
to a complete stop before removing the blade from
the workpiece.
12. Do not touch the blade or the workpiece
immediately after operation; they may be
extremely hot and could burn your skin.
13. Do not operate the tool at no-load unnecessarily.
14. Always use the correct dust mask/respirator for
the material and application you are working with.
GEB048-2
15. Some material contains chemicals which may be
toxic. Take caution to prevent dust inhalation and
skin contact. Follow material supplier safety data.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to safety
rules for the subject product. MISUSE or failure to
follow the safety rules stated in this instruction
manual may cause serious personal injury.
13. Loosen
14. Tighten
15. Hole for recipro saw blade
16. Blade clamp
17. Hole for jig saw blade
18. Projections
13 mm
0 - 3,300
50 mm
50 mm
355 mm
1.2 kg
D.C. 10.8 V
JR102D
1.1 kg
5