Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
TIMER
To set the Auto-off timer:
•
Ensure the appliance is turned on.
•
Press the timer button to set the timer to turn the
appliance off.
•
Press the temperature control buttons to
select the desired amount of hours before the
appliance turns off.
To set the Auto-on timer:
•
Ensure the appliance is turned off.
•
Press the timer button to set the timer to turn the
appliance on.
•
Press the temperature control buttons to
select the desired amount of hours before the
appliance turns off.
Notes:
•
The temperature control buttons will increase the
time in 0.5 hour increments up to 10 hours and
then in 1 hour increments up to 24 hours
•
The display will revert back to showing the
previous temperature setting if the appliance
does not receive a signal within a 5 second
period during programming
•
Turning the appliance on or off at any time
or adjusting the timer setting to 0.0 hours will
cancel the TIMER settings
ANTI-COLD AIR
The fan speed and the louver angle adjust
according to the ambient temperature. The manual
control button and remote control cannot adjust fan
speed or louver angle in this setting.
iFEEL
There is a temperature sensor built into the remote
control that will continuously collect the current
room temperature. Keep the remote control with
you and the appliance will automatically adjust
the temperature based on the current temperature
where you are located to reach the most
comfortable condition.
Press the iFEEL button to activate this feature. The
remote will display the current temperature at its
location. The remote will send a signal to the air
conditioner every 3 minutes, so long as you remain
within range of the appliance.
The iFEEL light on the control panel of the appliance
will illuminate for 5 seconds every three minutes
to indicate that it has received a signal from the
remote. If the appliance does not receive a signal
from the remote during any 10 minute interval,
it will beep to indicate that the iFEEL feature has
deactivated.
The maximum distance for the iFEEL feature is 8
meters (26 feet). This feature is available in cool and
auto modes.
iCLEAN
The iCLEAN feature can be used to remove dust
from the interior of the appliance and ensure that
the evaporator is dry. Press the iCLEAN button when
the appliance is turned off to activate this features.
The iCLEAN feature will run for approximately 30
minutes and then turn off. If the appliance is turned
on during this period, iCLEAN will be deactivated.
6
Publicité
