KEUCO X-Line 33298 1500 Serie Instructions D'utilisation page 6

EN
Technical data
– Power supply:
– max. Power consumption:
Prod. no.:
33298 XX1500:
33298 XX2000:
33298 XX2500:
33298 XX3000: 1000 mm
33298 XX3500: 1200 mm
– Protection rating:
– Ambient conditions:
Temperature
– Light colour
Mounting dimensions, see pages 2 and 3.
Circuit diagram, see fi gure 1 on page 18.
Installation, see fi gure 2 onwards on page 18.
Operation
The mirror can be optionally actuated similar to a toggle
switch with a button on the mirror (A) or with an external
light switch (B), see circuit diagram fi gure 1 on page 18.
Button functions
Button Function
Light on/off
• Pressing the button switches the mirror on with the
selected settings. The white LED goes off.
• Pressing the button again switches the mirror off.
The white LED lights up.
• The white LED can be deactivated.
– Switch on the mirror.
– Press and hold the button for 10 seconds.
- The lighting goes off.
- A short light impulse indicates that the white
LED was deactivated.
To switch the white LED back on, repeat the de-
scribed procedure.
6
Important information, please make sure to read!
230 V AC/ 50 Hz
Width Weight Light
500 mm 9.5 kg 27 W
650 mm 11.4 kg 30 W
800 mm 13.3 kg 33 W
15.9 kg 42 W
18.4 kg 48 W
5°– 40° C
2700 - 6500 Kelvin
A
Button Function
Front and wall lighting
• The front and wall lighting is switched on by press-
Heating
26 W
• Pressing the button again switches the light off.
41 W
52 W
Washbasin lighting
65 W
• The washbasin lighting is switched on by pressing
82 W
IP20
• Pressing the button again switches the light off.
When both lightings are switched off, the mirror also
switches off.
Dimming the front, wall and washbasin lighting
• Press the button when the mirror is switched on
The setting is stored and reproduced when switched
on again (only for connection type 1, see fi gure 1 on
page 18).
Setting the light colour cooler
• Press and hold daylight white button and the light
• Release when the desired light colour has been
The setting is stored and reproduced when switched
on again (only for connection type 1, see fi gure 1 on
B
page 18).
Adjusting light colour - daylight white (cool white)
• Press button and the colour temperature sets to
Setting the light colour warmer
• Press and hold warm white button and the light
• Release when the desired light colour has been
The setting is stored and reproduced when switched
on again (only for connection type 1, see fi gure 1 on
page 18).
Adjusting light colour - warm white
• Press button and the colour temperature sets to
Heating on/off
• Press button and the red LED lights up.
• Pressing the button again switches the heating off,
The heating switches off automatically after 20
minutes.
Replacement parts with order numbers, see pages 22
and 23.
The light sources may only be replaced by the
manufacturer, its customer service or by an equally
qualifi ed person.
For information about warranty and maintenance, see
the enclosed Maintenance and Warranty Passport.
Disposal information! Equipment with this labelling
must not be disposed of in household refuse, but must
be disposed of at a collection centre intended for this
purpose.
ing the button when mirror is switched on.
the button when mirror is switched on.
and hold until the desired brightness or the end
value has been reached.
colour fades to cool white.
reached.
6500 Kelvin.
colour fades to warm white.
reached.
2700 Kelvin.
and the red LED goes out.