Expondo MSW-CRF36A Manuel D'utilisation page 16

DISPOSAL OF USED UNITS.
At the end of its useful life, this product should not be disposed of with normal household waste but should
be taken to a collection point for the recycling of electrical and electronic equipment. This is indicated by
the symbol on the product, operating instructions, or packaging. The materials used in this appliance are
recyclable according to their marking. By reusing, recycling, or applying other forms of use of waste
machines, you make a significant contribution to the protection of our environment.
Your local administration will provide you with information about the appropriate disposal point for used
appliances.
ERROR CODES:
Error code
F1 The power supply voltage is too low.
F2 The condenser fan is overloaded.
F3 The compressor turns on too often.
F4 The compressor does not turn on.
Overheating of the compressor and
F5
electronics.
The controller does not read the
F6
parameters of the device.
F7 or F8
The temperature sensor is defective.
Possible cause Action
Switch the battery protection mode from high
to medium or from medium to low
Disconnect the power for 5 minutes and turn
the device on again. If the problem reappears,
contact the service center.
Disconnect the power for 5 minutes and turn
the device on again. If the problem reappears,
contact the service center.
Disconnect the power for 5 minutes and turn
the device on again. If the problem reappears,
contact the service center.
Disconnect the power for 5 minutes and turn
the device on again. If the problem reappears,
contact the service center.
Disconnect the power for 5 minutes and turn
the device on again. If the problem reappears,
contact the service center.
Contact service center