Publicité
Les langues disponibles
Les langues disponibles
Temperature setting: with the partition between the compartments inserted, press "+" or "-" to enter the
temperature setting for the left compartment chamber; press the setting button to toggle the temperature
setting for the left/right compartment. During normal operation, press and hold the "+" button and the
settings button simultaneously for approximately 3 seconds to switch the left compartment on/off.
Note: the temperature set in the left compartment must not be lower than the temperature set in the right
compartment and the right compartment cannot be switched off separately. The temperature value
displayed is the current temperature inside the compartments of the refrigerator, it takes some time for the
temperature to reach the set value.
Cooling mode : You can set two cooling modes: MAX (quick cooling) and ECO (energy saving). In normal
operation, press the setting button on the control panel to switch the cooling mode.
Battery protection mode from which the refrigerator is powered: You can set three protection modes for the
battery from which the refrigerator is powered: H ("High"), M ("Medium"), and L ("Low"). To switch modes,
press the settings button on the control panel during normal refrigerator operation and hold it for at least 3
seconds until the display screen starts flashing - then press the settings button again to switch to H, M, or L
mode.
Indicative values of battery voltage (there may be differences depending on the environment in which the
refrigerator is used):
Power supply
Mode
L
M
H
It is recommended that the H mode setting should apply when the device is connected to vehicle power,
while M or L should apply when the device is connected to a portable or backup battery.
Changing the temperature units : turn off the refrigerator and then press the setting button for 3 seconds
until the display shows E1. Press the setting button again to switch to E5, now use the "+" and "-" buttons to
set the desired temperature unit (Celsius or Fahrenheit).
Resetting the settings : turn off the refrigerator and then press the settings button for 3 seconds until the
display shows E1, at this point press and hold the "+" and "-" buttons simultaneously for a few seconds to
reset the settings.
3.4.
Cleaning and maintenance
a)
Pull the mains plug and let the unit cool down completely before cleaning, adjusting or replacing
accessories and when the unit is not in use.
b)
Open the cover and remove the protection from the drain hole at the bottom of the device.
c)
Use only non-corrosive cleaning agents for cleaning surfaces.
d)
Only mild detergents designed for cleaning food contact surfaces may be used to clean the unit.
e)
After each cleaning, all parts should be thoroughly dried before the device is reused.
f)
Store the unit in a dry and cool place protected from moisture and direct sunlight.
g)
Do not spray the unit with a stream of water or immerse it in water.
h)
Make sure that no water enters through the ventilation openings in the casing.
i)
Perform regular inspections of the unit checking technical fitness and any damages.
j)
Use a soft, damp cloth for cleaning.
k)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) as they may damage the surface
of the material from which the appliance is made.
l)
Do not clean the unit with acidic substances, medical agents, thinners, fuel, oils, or other chemicals. It
may cause damage to the device.
m) Defrosting: turn off the device and disconnect it completely from the power supply. Remove all food
from the refrigerator. Leave the lid open and wipe out the water coming from thawing. Never use hard
or pointed tools to remove or loosen items that have frozen inside the refrigerator.
DC 12V
Power cutoff at:
Power on at:
8.5V
10.1V
11.1V
Power cutoff at:
10.9V
21.3V
11.4V
22.3V
12.4V
24.3V
DC 24V
Power on at:
22.7V
23.7V
25.7V
Publicité
