shark ICZ160EU Serie Manuel D'instructions page 25

MAINTENANCE
CLEANING OR REPLACING BRUSH-ROLLS
BRUSH-ROLL
TURN LOCKS LIFT COVER
If you run over a hard or sharp object or notice
a noise change while vacuuming, check for
blockages or objects caught in the brush-roll.
1. Turn off the vacuum.
2. Using a coin, turn locks anticlockwise to open,
then lift off cover to access brush-roll.
3. Clear airway of blockages.
4. Replace cover by sliding inserts into slots,
then pressing down firmly on all sides before
turning locks clockwise to close. There will be
an audible click once the locks are secured.
NOTE: To order replacement parts and filters, visit sharkclean.eu.
48
s h a r kc l e a n . e u
SOFT ROLLER
1. Slide Eject Roller button forward.
2. To remove Soft Roller, pull the tab on the right.
3. Tap loose debris off the Soft Roller. Use a dry
towel to wipe clean, or to remove any hair or
fibres caught in the teeth behind the Soft Roller.
4. Rinse as needed. Use ONLY lukewarm water,
and leave to air-dry completely for at least
24 hours.
5. When dry, insert the left end of the roller first,
then push the right end into place with the
word Front facing forward.
MAINTENANCE
CHECKING FOR BLOCKAGES
IMPORTANT: DO NOT use sharp or metal objects to clear blockages.
Detach hose from vacuum pod,
and check opening on back of
pod for blockages.
Detach handle from wand and
hose from the vacuum pod, and
check openings for blockages.
Detach wand from floor
nozzle. Tilt nozzle neck back
to straighten the airway, and
remove any blockages.
NOTE: Turn off vacuum and remove battery before checking for blockages
Detach dust cup from vacuum
pod. Empty dust cup, remove
debris from lint screen, and
check for blockages.
Detach wand from floor nozzle
and handle, and check both
ends of wand for blockages.
s h a r kc l e a n . e u
49