Publicité
Les langues disponibles
Les langues disponibles
5
OUTER LEG /
PIED EXTÉRIEUR
LEG RETENTION BRACKET /
SUPPORT DE FIXATION DES PIEDS
SIDE VIEW A / VUE LATÉRALE A
LOCKING BAR /BARRE DE VERROUILLAGE
RETENTION BRACKET CLIPPED ON TOTUBE /
SUPPORT DE FIXATION CLIPSÉ SUR LE TUBE
06
MATTRESS / MATELAS
OUTER LEG /
PIED EXTÉRIEUR
EN
1) Carefully remove plastic wrap and cardboard packing and cut
plastic band.
2) Open bed and remove parts for assembly.
3) Closed bed and snap clip-lock bar using slots (1) and (2 as shown
in illustration.Do not use slot (3).
4) Lay folded bed on one side (See picture n°1)
5) Open two center legs (See picture n°2 )
6) Place the flat side (top) of the leg cross-bar (item E) against the
bottom of the central leg,align holes,insert caster (A) into hole and
secure using nut (B). Repeat with remaining three casters (See
picture n°3)
7) Stand bed upright and insert the four plastic leg caps (C) by
inserting the center tabs into the holes on the outside legs (See
picture n°4)
TO USE BED:
1) Unfold legs by pulling each leg upward until it is perpendicularar
to side of folded bed.
2) Release the Clip-Lock Bar on top of folded bed by grasping finger
hold at one end and pulling upward.When Clip-Lock Bar
releases,lower one side of the bed until leg rests on floor.Then.lower
opposite side of bed until leg rests on floor and bed is fully opened.
3) Once the outer legs are fully extended,secure retention brackets
from the frame to extended outer legs (see picture n°5)
NOTE:AS CLIP-LOCK IS RELEASED.HOCD HANDLES ON TOP
OF BED TOPREVENT BED FROM OPENING TOO RAPIDLY.
After use,fold bed and secure with Clip-Lock Bar for easy storage.
07
Publicité
