Calienta 10626737 Mode D'emploi page 28

I.
1
4
2
3
5
6
II.
1. 2.
4. 4. 5. 5.
7. 7. 8. 8.
I.
Description
1
Air outlet
2 Stand
3 Wheel
4
Temperature dial
5 Main switch
6 Indicator
II.
Operation
3.
Caution: Remove any packaging before use. Store packaging out of reach of children and use it to
protect the heater during standstill. Check the heater, the power cord, and the power plug for damages.
Do not use the heater if there are any visible signs of damage.
1. Click two wheels into each of the stands.
2. Fix both stands to the heater with the four screws.
3.
Position the heater on a firm and absolutely level underground observing the spacing shown in fig. 3 on
the left fold-out-page.
4. Plug the appliance to a suitable 220-240 V~ 50-60 Hz socket.
5. Turn the temperature dial clockwise until it stops.
6. 6.
Switch on the heater by turning the main switch to power level 1 (1000 W) or 2 (2000 W). The indicator
is lit as long as the heater is operating.
7. If the room temperature reaches the desired value, turn the temperature dial anti-clockwise until the
heater and the indicator turn off with a click. If the temperature falls below this value the heater switches
on again automatically.
8. Turn the main switch to 0 to switch off the heater. Let the heater cool down at least 5 min before touch-
ing it.
9. Always unplug the appliance when not in use.
9.
54
III.
Technical data
Nominal voltage 220-240 V~
50-60 Hz
Rated power 2000 W
Protection class I
Overheat protection IPX0
IV.
Maintenance and care
Caution: Before performing any maintenance and care always unplug the heater and let it cool down.
Cleaning
Wipe the heater with a soft, damp cloth only. Never use scouring powders or chemical cleaning agents.
Never allow the electrical components to become damp.
Trouble shooting
Problem Cause Solution
The heater does not heat. The power supply is off. Check the fuse. Do not connect the
heater and other appliances to the
same circuit.
Main switch set to 0. Set the main switch to one of the
power levels.
The ambient temperature is Wait until the ambient temperature
above the temperature set at the falls below the set value.
temperature dial.
Increase target temperature at the
temperature dial until the heater
and the indicator switch on.
The overheat protection shut Unplug the heater and let it cool
down the heater. down for at least 10 min.
Make sure that neither the air
intake nor the air outlet is blocked.
If the problem persists, do not use
the heater any more and contact
your local HORNBACH store.
55