OEM FX Série Mode D'emploi Et D'entretien page 48

5.2.d - Head lifting (For models being equipped with)
(Fig.3)
DANGER
The head (1) shall be lifted when the machine does
not function and the cutout switch placed at the
upper part of the machine is off.
The machine is equipped with a safety microswitch,
which stops the machine functioning in case of a
lifting of the head.
• Loosen both knobs (2) placed on both structure sides,
until the head (1) is released.
• Lift the head (1), completely; the head position is kept
by the hydraulic absorber (3).
• To lower the head, make sure the coupling between
the head joint (4) and the motor joint (5) is correct, if it
is not the case, manually rotate the spiral element (6)
to allow the two joints to fit together.
• Tighten the knobs (2) to fix the head.
GB - 18
FIG. 3
4
5
1
6
3
FX / RVE
Functioning
3
2