Cooper Lighting Solutions PORTFOLIO LSRUD2B Instructions D'installation page 3

Installation Instructions – LSRUD2B/ LSSQUD2B Commercial LED Rough-In
Place Lens Over
Trim. Peel Away
Backing Material
Figure 5.
Cleaning
To Clean Trims:
1. Gently wipe with soft, clean, dry lint-free cloth to
remove dust.
2. Wipe with mild detergent solution on a soft, clean
cloth to remove fingerprints and stains.
3. Rinse with clean water and dry with soft, clean, dry
lint-free cloth.
Installation Instructions – LSRUD2B/ LSSQUD2B Commercial LED Rough-In
IB520121ML
Electrical Connection
Make certain no bare wires are exposed outside of wire nut
connectors.
1. Provide electrical service according to the "National
Electrical Code" or your local electrical code to the
cylinder housing assembly. Supply wire insulation must
be rated for at least 90°C.
3. Connect supply lead wires to cylinder housing lead
wires (line, neutral and ground) in the fixture using the
provided lever nut connectors. Be careful not to leave
any bare conductors outside of the connectors.
4. Lift the orange tab on the lever nut to disengage the
wire and close to secure the wire in place (Figure 6).
5. Connect white to white, black to black, and green (from
electrical service) on the supply side to the bare copper
wire in the cylinder housing assembly. For dimmer
wiring, see electrical Wiring Diagram section.
Lever Closed
Close Lever To
Secure Wire
Figure 6.
www.cooperlighting.com
CAUTION
Lever Open
Open Lever To
Release Or Insert
Wire
3