Klarstein 10030930 Mode D'emploi page 32

All manuals and user guides at all-guides.com
Die richtige Spülmittelmenge
Amount of detergent to use
Fill the detergent dispenser with detergent. The marking indicates the
dosing levels , as illustrated on the right:
1. The place of main wash cycle detergent placed, MIN means appro-
ximately 20g of detergent.
2. The place of pre-wash cycle detergent placed, approximately 5g
of detergent.
Please observe the manufacturer's dosing and storage recommendations as stated on the detergent packaging.
Close the lid and press until it locks in place. If the dishes are heavily soiled, place an additional detergent dose
in the pre-wash detergent Chamber. This detergent will take effect during the pre-wash phase.
There are 3 sorts of detergents:
• With phosphate and with chlorine
• With phosphate and without chlorine
• Without phosphate and without chloride
Normally new pulverized detergent is without phosphate. The water softener function of phosphate is not
given. In this case we recommend to fill salt in the salt container even when the hardness of water is only 6
dH. If detergents without phosphate were used in case of hard water often white spots appear at dishes and
glasses. In this case please add more detergent to reach better results. Detergents without chlorine do only
bleach a little. Strong and coloured spots will not removed completely. In this case please choose a programme
with higher temperature.
Use of 3-in-1 detergent tablets
ATTENTION: Before using these products you should first check that the water hard-ness in your supply is
compatible with the use of these products as per the detergent manufacturers instructions (on the packaging).
When using combination products, the rinse-aid and salt lights are no longer useful. It may be helpful to select
the lowest possible setting for water hardness.
Using the 3-in-1 function
• If you use 3-in-1 peoducts use the 3-in-1-function. in1washing cycle is additional function, they must be
used with other programme (Intensive, Eco and Light).
• To select 3-in-1 function press the power switch and select the 3-in-1 washing cycle by pressing the option
button 3-in-1 until the „3in1" indicator blinks.
• The 3-in-1 washing cycle will be available after pressing the Start/Pause button.
• If you decide to switch to the use of a standard detergent system we advise that you refill both the salt and
rinse aid compartments. Switch the water hardness setting to the highest possible position and run for three
normal cycles without load.
• Readjust the water hardness setting again according to the conditions for your region (For more information
please refer to your instruction manual).
32