Klarstein 10030930 Mode D'emploi page 30

All manuals and user guides at all-guides.com
How to fill the rinse aid dispenser
1. To open the dispenser, turn the cap to the „open" (left) arrow and lift it out.
2. Pour the rinse aid into the dispenser, be careful not to overfill.
3. Replace the cap by inserting it aligned with „open" arrow and turning it to the „closed" (right) arrow.
The rinse aid is released during the final rinse to prevent water from forming droplets on your dishes that can
leave spots and streaks. It also improves drying by allowing water to sheet off the dishes. Your dishwashers are
designed to use liquid rinse aids. The rinse aid dispenser is located inside the door next to the detergent dis-
penser. To fill the dispenser, open the cap and pour the rinse aid into the dispenser until the level indicator turns
completely black. The volume of the rinse aid container is about 140ml. Be careful not to overfill the dispenser,
because this could cause over sudsing. Wipe away any spills with a damp cloth. Don't forget to replace the cap
before you close dishwasher door.
ATTENTION: Clean up any rinse aid split during filling with an absorbent cloth to avoid excess foaming during
the next wash.
How to adjust the rinse aid dispenser
The rinse aid dispenser has four or six settings. Always start with the dispen-
ser set on „4" If spots and poor drying are problems, increase the amount of
rinse aid dispensed by removing the dispenser lid and rotating the dial to „5 .
If the dishes still are not drying properly or are spotted, adjust the dial to the
next higher number until your dishes are spot-free. The dose is factory set in
position 5. Increase the dose if there are drops of water or lime spots on
the dishes after washing. Reduce it if there are sticky whitish streaks on the
dishes or a bluish film on glassware or knife blades.
30