IKEA UPPLEVA Mode D'emploi page 11

3 Preparation
Always follow the instructions in this chapter
in sequence.
Note:

Use of controls or adjustments or
performance of procedures other than
herein may result in hazardous radiation
exposure or other unsafe operation.
Prepare the remote control
1. Open the battery compartment.
2. Insert two R03 batteries with correct
polarity (+/-) as indicated.
3. Close the battery compartment.
Notes:

If you are not going to use the remote
control for a long time, remove the
batteries.

Do not use old and new or different
types of batteries in combination.

Risk of explosion! Keep batteries away
from heat, sunshine or fire. Never
discard batteries in fire.
•
The maximum operable ranges from the
unit are as follows.

Line of sight: approx. 9 m

Either side of the centre: approx. 7 m
within 30°

Above: approx. 7 m within 30°

Below: approx. 7 m within 30°
4 Connection
Make the following connection to use this
product.
Connecting to a TV
Connect the product to TV to view disc play.
Select the best video connection that TV can
support:
Connect to the HDMI connector
This type of connection provides better
picture quality.
All manuals and user guides at all-guides.com
Connect a HDMI cable from the HDMI output
connector on this product to the HDMI input
connector on the TV.
Notes:



Aux in connection
Connect to an analogue stereo system
Recommend to connect to HDMI ARC
connector on TV if available.
If the TV has a DVI connector only,
connect via an HDMI/DVI adapter. You
can enjoy the picture from DVI and the
sound from the speaker.
You can optimize the video output, in
SETUP menu, select [PICTURE] > [TV]
> [Resolution], and then press left/right
cursor button on remote control to select
the best resolution the TV can support.
11
SPK_R 8
AUDIO OUT
TV or other device.
SPK_R 8