Publicité
Fax +32 2 359 95 50
use strong cleaning substance (scouring liquids, thinners), since these will corrode the plastic
surface. Only place the plug back in the mains socket when you have made sure that all the
parts are thoroughly dry.
Hair and fluff may gather on the running wheels and on the floor nozzle of the vacuum cleaner
in time.
You should remove these to ensure that handling of the vacuum cleaner is always easy.
Note! Lubricating or oiling of the roller bearing is not recommended, because this will cause dirt
and fluff to stick even better.
PRACTICAL HINTS
•
When cleaning stairs, we advise you to keep the unit in a vertical position.
•
The floor brush is equipped with a hook, allowing you to attach the tube to the rear part of
the appliance when it is in use, for instance when you want to move a piece of furniture,
or after use when storing your appliance.
•
The vacuum cleaner requires no regular maintenance other than the filter cleaning tasks
as detailed here above.
TROUBLE-SHOOTING
Faults can occur on all electrical equipment. This must not necessarily be due to a defect in
the device itself. So check first with table if the fault can be dealt with.
PROBLEM
Weak suction
Device does not work
Whistling sound during
The first hours of
operation
The device cover does
not close properly
Never try to repair a defective device, or a device you believe to be defective, by
yourself. You can put both yourself and future users in danger. Repairs may only be
carried out by authorized specialists.
ABOUT THE PACKAGING
Our packaging is made of materials that are harmless to the environment. They can be
recycled and do not cause pollution. These materials are:
•
The outer packaging is made of cardboard.
•
The wrapping and bags are made of polyethylene (PE).
All manuals and user guides at all-guides.com
Copies of the I/B. Please reproduce them without any
changes
except
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
POSSIBLE CAUSES
The secondary valve is
open
An object is blocking the
suction pipe
Filters are not fitted
properly or are blocked
Device is not properly
plugged into the mains
This is not a fault
Dust container is not set
properly
16
Assembly page 16/67
under
special
instruction
SOLUTIONS / TIPS
Close the secondary valve
Check the suction tube, the
handle area, suction pipe and
the nozzle in use for blockages
Fit a new filter
Check that the mains plug has
been inserted properly. Also
check whether the power
socket is in order. Check the
fuses! Automatic fuses in the
fuse box
The noise will die away by itself
after a time
Check the dust container fit
TKG VC 1022 - 170214
from
Team
Publicité
