Publicité
Les langues disponibles
Les langues disponibles
Installation Steps
Remove hood shield from hood. Remove the corresponding factory installed rubber seal retaining fasteners that were marked in Step 2.
NOTE: Some applications may require additional fasteners to be removed in order to fully access the holes underneath.
3
Center hood shield on hood, and slide hood shield flanges UNDER the rubber seal. Align hood shield flanges with holes in hood.
4
5
6
NOTE: Actual application may vary slightly from illustrations.
Install a fastener at each OUTBOARD flange location.
X2
Hood
Hood Shield
Rubber Seal
Fastener
Do not overtighten
I
nstall a screw at each INBOARD flange location.
X4
Hood
Hood Shield
Rubber Seal
Screw
Do not overtighten
NOTE: Exercise extreme caution not to tear
or damage the rubber seal when separating
from hood.
Page 2 of 3
Publicité
