Power One AURORA PVI-AEC-EVO Guide D'installation Rapide page 19

M. Firmware updating procedure via SD Card
The firmware update via SD card should be carried out only if it is not possible to update the firmware
viatheWebPortal.
1. Access the display by entering the user password 0000.
2. Check and note the current firmware versions installed:
3. Turn off the PVI-AEC-EVO and wait at least one minute.
4. Disconnect all available connections from the PVI-AEC-EVO (RS458 line(s),LAN connection,sensors).
5. Remove the SD Card from the slot on the PVI-AEC-EVO front panel by pressing the SD Card gently.
6. Insert the SD Card into the SD Card reader or into to the SD Card reader slot of the PC.
7. Delete the folders upgrade,web,lang and config from the SD Card.
8. Copy the new folders upgrade,web,lang and config into the root of the SD Card.
9. Remove the SD Card from the SD Card reader or from the SD Card reader slot.
10. Insert the SD Card into the slot on the PVI-AEC-EVO front panel by pressing the SD Card gently to lock it into place.
11. Turn on the PVI-AEC-EVO and wait about one minute.(N.B.: Power failure during update may cause serious damage
to the device).
12. Access the display by entering the administrator password 0010.
13. Access the menu Settings > Upgrade Firmware > Upgrade AVR
system will to confirm the command by displaying the message"
14. Press ENTER to update the firmware.
15. Wait until the update (during the update the message "
completed (during reboot the message "
time are displayed.
16. Access the display by entering the administrator password 0010.
17. Access the menu Settings > Upgrade Config.
message" Are you sure?
18. Press ENTER to update the PVI-AEC-EVO configuration.
19. During the update the message "
completed. At the end of the update the menu
20. Switch off the system,restore all connections (RS485 line(s),LAN connection,sensors),then switch on the system.
All manuals and user guides at all-guides.com
Monitoring System
Information > Product > Firmware AVR
Information > Product > Firmware Display
Information > Product > Firmware IO
Waiting for Reboot
The system will ask to confirm the command by displaying the
" .
Waiting for Load
Settings > Upgrade Config
18- EN
. If the procedure was carried out correctly,the
Are you sure? " .
Waiting for Load " is displayed) and the reboot are
"is displayed).The reboot is completed when date and
" will be displayed. Wait until the configuration update is
will be displayed.