Red Sea ReefMat 250 Mode D'emploi page 26

Red Sea ReefMat 250
®
Partial Roll
In the event that you have removed a partially used roll of fleece-mat
and wish to use it at a later time you should select the "Partial roll"
option when installing it as a new roll.
To get full functionality, it is best to measure
the external diameter of the roll before
installing it on the dispensing shaft and enter
this value in the ReefBeat App.
As a guide the diameter of the side disk is
98mm 3.9".
If you choose not to enter the diameter, the ReefMat will continue
filtering the aquarium correctly however the system will not be able to
monitor the exact usage and the end-of-roll notification will be disabled.
26
Removing used fleece-mat from the Take-up shaft
Remove the retaining nuts by
rotating counter-clockwise.
Remove the side disks by pushing
the 2 halves of the shaft through
the disk.
Slide the 2 halves of the shaft out
from the used fleece-mat, one at
a time.
Reassemble the take-up shaft ready
for next use.