Red Sea ReefMat 250 Mode D'emploi page 19

Thread the free edge of the fleece-mat into
the slot in the take-up shaft and rotate the
top side forwards (so that the new material
comes from the bottom rear of the shaft)
for a few turns to firmly attach the material
to the shaft. Lower the shaft to its operating
position in the Head and rotate slightly as the
gears on the shaft engage with the gears on
the drive-unit. Close the side locks to hold the
shaft in position.
Check that the seals are mounted on both sides of the retainer. Aline the external
rollers with the outer edges of the fleece-mat. Carefully lower the retainer inside
the chamber until it is firmly seated at the bottom and the retainer handle is
in its slot in the head. The mat will naturally unwind from the new roll while
lowering the retainer as the take-up shaft cannot rotate freely.
Red Sea ReefMat 250
®
ENG
19