Red Sea ReefMat 250 Mode D'emploi page 12

Red Sea ReefMat 250
®
Note: This part has a left-hand thread. The pipe can be used before
the sealant is dry. The other side of the universal connector
can be glued to standard 32mm or 1" PVC piping.
Alternatively, the free end of the corrugated hose can also be attached
directly to standard 32mm diameter PVC tubing as used in most Red
Sea Reefer series systems. This join is not under any water pressure,
however it is advisable to use the liquid sealant and secure the
corrugated hose in place with a cable tie.
12
32mm
Installation of the ReefMat
Rotate the Take-up Shaft Locks to the
open position and remove the take up
shaft from the ReefMat Head. Unlock
the front flap by raising the handle
and rotate the flap forwards to its
horizontal position and remove the
dispensing shaft.
Raise the mat-retainer fully out of the
filter chamber, close the flap and lock
in position by lowering the handle.