Evolite EVOWASH1240Z-R Mode D'emploi page 13

buttons. Press ENTER to confirm your choices and values.
MENU (page 14) and DMX PROTOCOL (page 16) > see end of manual
Selecting DMX mode via cable :
Press MENU then DOWN to access the next menu. Then press ENTER then DOWN to reach the Mode select menu.
Press ENTER then tick the DMX box. Confirm your choice by pressing ENTER.
Press MENU then UP to reach the first menu. Press ENTER to select the Dmx Address menu. Use the UP & DOWN keys
to select the DMX address of the fixture. Press ENTER to confirm your choice. Finally, press MENU twice to return to
the main menu.
 Care and maintenance
o Cleaning
The outside of the camera should be cleaned regularly. The lenses must be cleaned to ensure optimum brightness. If
the luminaire is installed in a dusty or smoky environment, regular cleaning is very important. Unplug the device
before carrying out any work!
Use a clean, dry cloth.
o Maintenance
Risk of electric shock.

Always unplug the appliance before servicing or performing any maintenance.
Here are a few suggestions if you have any problems with your device.

The appliance does not work at all.
o Check the power cord and fuse.
o Make sure that your plug is correctly plugged in.

The fixture does not respond or does not respond correctly to DMX commands.
o Check your DMX cables
o Check your DMX addressing
o Try another DMX controller
o Check that your DMX cables do not run close to high-voltage cables, which could cause interference.

Does not react to sound
o Check the selected operating mode
o Check that there is no DMX cable connected to DMX IN
o Tap directly on the microphone to test its responsiveness.
 Technical specifications
Model
Voltage
Consumption:
Evowash1240Z-R User's Manual Ver. 1.00
DANGER!
EVOWASH1240Z-R
AC100- 240V / 50-60Hz
500W
13
Page