Display AND COMMANDS
Turning On and Off
Press the multifunction button (12) once to turn on the scooter; press and hold it for
3 seconds to turn it off.
Select the speed level
The scooter has three speed levels.
To change the speed level, with the scooter on, quickly press the multifunction but-
ton (12) twice until the indicator corresponding to the desired speed level (4) appe-
ars on the display:
- In LOW mode (6Km/h), the letter "L" will appear on the display;
- In MEDIUM mode (20Km/h), the letter "M" will appear on the display;
- In HIGH mode (25Km/h), the letter "H" will appear on the display.
Note: When LOW (L) mode is selected, the lights and running board will automatical-
ly activate and flash to make your scooter more visible to people on cycle/walkways.
Turn On the front and rear LED light
The scooter is equipped with automatic switching on of the lights via a sensor loca-
ted on the display. If you want to activate them manually, press the multifunction
button (12) once to switch both LED lights on/off.
Note: The front LED is white while the rear LED is solid red. Pull the drum brake
lever or depress the electronic brake control to flash the LED taillight.
Speed measurement unit
Quickly press the multifunction button (12) three times: change the speed unit of
measurement, from Km/h to mph and vice versa, is shown on the display (3).
Signal lights.
The scooter is also equipped with signal lights, which can be easily activated by the
control (9) positioned on the handlebar. The left arrow controls the left signal light,
and vice versa.
Cruise control.
The scooter is also equipped with the cruise control function.
The function is activated automatically by maintaining a constant speed for approxi-
mately 5 seconds.
The cruise control keeps the engine power constant (the speed can vary depending
on the slope of the ground) even if the accelerator is not pressed. The cruise control
function is interrupted by pressing any brake lever or the accelerator.
39