Télécharger Imprimer la page

Bosch HCP3 651UC Serie Instructions D'installation page 11

Publicité

Les langues disponibles

Les langues disponibles

Mounting
the back-pressure
flap
Using 4 screws (4x8 mm), attach the back-pressure
flap
to the extractor hood.
B IZ I!
A
Connecting
the air extractor
(only for
ducted operation)
Note: If an aluminum pipe is used, smooth the
connection
area beforehand.
1. Attach exhaust air pipe and seal.
2. Check whether the back-pressure
flap works.
Mounting the recirculation
model (only for
circulating-air mode)
1. Use 4 screws (4x8 mm) to screw the housing to the
angle bracket.
A
Recirculation
module
B
Clamps
C
Flue duct
D
Exhaust air duct
3. Shorten the exhaust air pipe to the length measured.
4. Remove the recirculation
module.
5. Push the exhaust air pipe onto the bottom side of the
recirculation
module.
6. Position the recirculation
module with exhaust air pipe
over the air extraction duct of the extractor hood.
7. Use 4 screws to fasten the recirculation
module to the
angle bracket.
8. Secure connections
with clamps.
A
Screws
B
Recirculation
module
C
Angle bracket
2. Measure the distance (x) between the bottom edge of
the housing for the recirculation
module and the
bottom edge of the back-pressure
flap.
11

Publicité

loading

Ce manuel est également adapté pour:

Hcp36651uc/01Hcp30651uc/01