Bruder Mannesmann Werkzeuge 22400 Instructions De Service page 13

Before Using Equipment
• It is recommended that a circuit breaker be professionally fitted to the power supply to
this equipment, to interrupt the supply voltage, should the current exceed 30mA for
30ms.
According to the applicable regulations, the appliance must never be used on the
•
drinking water supply without a system separator. Use a suitable system separator as
per EN 12729 Type BA. Always connect the system separator to the water supply,
never directly to the appliance!
Connect the high-pressure hose (8) firmly to the high-pressure outlet (5).
•
Insert the free end of the high-pressure hose (8) into the corresponding opening on the
•
spray gun until you hear it click into place. Press the release button (15) to remove the
high-pressure hose from the spray gun and pull the hose out.
Connect the water supply hose to the water inlet valve (7) or to a preassembled hose
•
coupling (18). Make sure the dirt filter (17) is correctly positioned.
Firmly twist the lance (6) into in the trigger gun (1).
•
Depending on requirements, insert one of the jet nozzles into the spray lance until it
•
you hear it click into place. To change the nozzle, pull the locking cap (16) back
towards the spray gun and remove the nozzle by pulling it forwards.
• Connect the mains plug to a properly earthed socket.
Turn on water supply. Using the high-pressure cleaner with the water supply
•
disconnected causes damage to the pump.
Switching On
Turn the operating switch (3) into the "ON" position
•
Aim trigger gun (1) towards the ground.
•
Release the trigger lock (13) on the trigger gun (1) and fully depress the trigger (14).
•
Switching Off
Let go of the trigger (14) and lock it in position using the trigger lock (13).
•
During longer breaks you should switch off the high-pressure cleaner by turning the
•
operating switch (3) to "OFF"
Foam nozzle
Your high-pressure cleaner is equipped with a foam nozzle (10). If required, detergent can
be automatically mixed into the cleaning water.
Disconnect the high-pressure cleaner from the mains, before mounting the foam nozzle
•
(10).
Insert the foam nozzle (10) into the trigger gun (1) as described above. Please observe
•
the detergent-bottle must be positioned downwards
• Screw-off the detergent-bottle and fill up with detergent observing the maker´s
instructions.
Screw the bottle to the foam-nozzle and pull the trigger (14) of the spray-gun.
•
Spray detergent onto the dry surface and let it react, but not dry-out, for some minutes.
•
Remove the foam-nozzle (10) from the trigger gun, fasten the fan-nozzle (9), as
•
described above and clean the object with the jet-stream
GB - 13