Publicité
ENGLAND
m) Never lift the rear of the mower while starting the engine
or during normal operation.
n) If the blade happens to hit any obstacle, stop the engine
at once and remove the spark plug cap. Then get an
expert to examine the blade.
Maintenance and storage
a)Make sure that all nuts, bolts, and screws are kept well
tightened to keep the mower in a safe operating condition.
MAINTENANCE
lFor a four stroke engine, check the oil level and change the oil when dirty. For further
explanation, see ENGINE INSTRUCTION BOOK.
lFrequently check the mower and ensure that all grass deposits are removed from
beneath the deck.
lNever clean the mower by pouring water over it: this may seriously damage the electric
start system.
L
BLADE
IJ=HJI=JF=CA!&
lTo remove the blade (15) unscrew the screw (16).
lCheck the conditions of the blade-support (17), the washer (18), the key (19) and the
washer (20) and replace any parts which are damaged.
All manuals and user guides at all-guides.com
b)Never leave the machine with fuel in the tank within an
enclosed area where the fuel vapours could reach naked
flames or sparks.
c)Allow the engine to cool before storing in any enclosure.
d)Keep the engine, silencer, battery compartment and
petrol tank free from grass, leaves and excess lubricant,
in order to reduce the danger of fire.
e)Frequently check the grass catcher for wear or
deterioration
Caution! Switch off the motor and disconnect the spark plug before undertaking any
maintenance work.
f)For safety reasons, be sure to replace worn-out or
damaged parts in due time.
g)If the fuel tank has to be drained, it is essential that this
be done outdoor.
h)Assemble the blades following the corresponding
instructions and use only blades bearing the maker's
name or the trademark of the manufacturer or supplier
and marked with the reference number.
i)To protect hands during disassembly or assembly of the
blades, it is absolutely essential to wear suitable
protective gloves.
lTake care, the exhaust muffler may be very hot.
lFrequently remove the wheel screws clean whith petroleum and oil before replacing.
Ball bearings must be greased before remounting.
lFrequently check the blade for damage.
lThe lawn mower must be checked by a SERVICE DEALER.
lWhen reassembling, make sure that the key (19) is correctly seated in the shaft and
that the cutting edgles face in the direction of the engine rotation. The blade screw (16)
must be torqued to 5,34 Kgm (52,4 Nm).
8
Publicité
