Seifert L35L35 Mode D'emploi page 14

Menu 3
Parameter Description
Add Modbus Address
SLoc Setpoints Lock
CPSS Change Password
MS1 Master Enable
MS2 Master Mode
Power Mode Delta
MdL
Temperature
rS1 Redundancy Mode
rS2 Redundancy Start-up △ or ▽ to increase starting units
rS3 Redundancy Timeout △ or ▽ to increase time (Minutes)
Alarm codes
Alarm Code
AL1 - HI
AL2 - LO
AL3 - PrEP
AL4 - AbS
AL5 - PPS
AL6 - ICES
AL7 - InS
NA
AL9
AL10 - ICE
AL11 - SLOC
Digital Input 2 Table
dIn2
PH_F
Pr_S
FL_S
Test mode
Test mode is started by simultaneously pressing △ and ▽ for 3 seconds from the Home screen.
When Test run is active, tESt will be shown blinking on the display.
Test procedure when Internal Temperature is between 50°F and 122°F.
0 - 30 seconds
30 seconds - 5:30 minutes
5:30 - 6:30 minutes
Revisions Nr. 1-15 - 06.12.2023
Input
△ or ▽ to increase or decrease Modbus address
△ or ▽ to change between Locked/Unlocked
△ to increase number and ▽ to change digit
Master On/Off
△ or ▽ to change Master Mode
△ or ▽ to increase or decrease temperature
△ or ▽ to change between Redundancy
Modes
Description
High Temp Alarm
Low Temp Alarm
Pressure Pipe Alarm
Ambient Sensor Faulty
Pressure Pipe Sensor Faulty
Ice Sensor Faulty
Internal Sensor Faulty
Not Available
...Check 'Digital Input 2' Table below
Ice Algorithm Active
Incorrect Sensor Location
Generic Error
Phase Failure
Pressure Switch
Float Switch
Ambient blower
Ambient blower + compressor
Ambient blower + heater
Doc. nr. 99871220201USL
Setting range
Any number between
1 and 254
0: Unlocked
1: Locked
Any number between
0 and 9998
ON: Master On
OFF: Master Off
NONE: None
IDN: Identical Mode
PR: Power Mode
Min: 0
Max: 9999
NONE: None
A: Redundancy Mode A
B: Redundancy Mode B
Min: 1
Max: 10
Min: 0
Max: 9999
14 / 25