All manuals and user guides at all-guides.com
1-888-559-8550
CALL
TO FIND A LOCAL AUTHORIZED SERVICE CENTER NEAR YOU FOR REPAIRS
AND SERVICE PART PURCHASES
This pump does not require oil.
OIL
Use only cold water.
Don't operate unit with clogged or missing water filter/screen.
WATER
Don't operate unit without adequate water supply to pump. Adequate
water supply is a minimum of 20 psi and 5 gpm.
The pressure setting is preset at the factory to achieve optimum cleaning.
PRESSURE
If you need to lower the pressure setting, refer to the owners manual for
ADJUSTMENT
proper procedure.
Pull gun trigger every 2 minutes while motor is running.
Don't allow water to freeze in pump.
PUMP
Siphon RV antifreeze into pump for cold weather storage or long term
storage.
Never leave unit running for more than 2 minutes without pulling gun
BY-PASS MODE
trigger; doing so may damage pump and void warranty.
Pump is equipped with a thermal relief valve. If the water overheats, this
THERMAL
valve will open and allow a gush of water to escape. Once the water is
RELIEF VALVE
released, the valve closes allowing the pump to operate normally.
Don't allow hoses to contact the HOT motor during or after use.
HOSE
Never pull the hose to move the unit.
Use only soaps and chemicals designed for pressure washer use..
SOAP/CHEMICALS
NOZZLE
Keep nozzle unclogged. Refer to manual for cleaning procedures.
Chemical/soap cannot be siphoned in high pressure setting. Only in low
setting.
MAINTENANCE
Follow recommended maintenance schedule for motor & pump. Refer to
SCHEDULE
manual.
Draw clean water through chemical inlet.
STORAGE OR
Don't allow water to freeze in pump, gun, wand or hoses.
WINTERIZING
Siphon RV antifreeze into pump for cold weather storage or long term
storage.
ALWAYS REFER TO THE MANUALS SUPPLIED WITH THIS UNIT
QUICK FACTS
.
19- ENG
D25801