Publicité
Les langues disponibles
Les langues disponibles
TROUBLE SHOOTING GUIDE
PROBLEM
Pressure washer not plugged in.
Motor will not
"RESET" button on GFCI not
start and there
pushed.
is no humming
sound
Circuit breaker has tripped or fuse
is blown.
Power source
Too much load already on circuit.
circuit
continues to
trip or blow
fuses
Motor hums but
Using an extension cord.
will not start
Pump is stuck due to dirt, mineral
build up, or ice.
Wand not in high pressure.
No or low
pressure
(initial use)
Low water supply.
Leak at high pressure hose.
Nozzle obstructed.
Water filter screen clogged.
Defective E-Z start valve.
Air in hose.
High pressure hose is too long.
D25801
All manuals and user guides at all-guides.com
CAUSE
16- ENG
CORRECTION
Plug in pressure washer.
Push "RESET" button.
Reset breaker or replace fuse.
Reduce load on circuit.
Try another 15 amp circuit.
DO NOT use extension cords.
Unplug unit. If temperature is
below freezing do not use. Thaw
in a warm area.
See How to Use Wand paragraph
in the Operation Section.
Water supply must be at least 5
GPM @ 20 PSI.
Repair leak. Apply sealant tape
if necessary.
Clean nozzle with paper clip or
nozzle cleaning tool, pour water
into nozzle end to flush out ob-
struction.
Remove and clean filter.
Check with Authorized Warranty
Service Center (AWSC.)
Turn off the motor, then the
water source. Disconnect the
water source from the pump
inlet and turn the water source
on to remove all air from the
hose. When there is a steady
stream of water present, turn
water source off. Reconnect
water source to pump inlet and
turn on water source. Squeeze
trigger to remove remaining air.
Use high pressure hose under
100 feet.
Publicité
