Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
PROBLEM
Wand not in low pressure.
Will not draw
chemicals
Chemical filter clogged.
Chemical screen not in chemical
Chemical too thick.
Pressure hose is too long
Chemical build up in chemical
injector.
Worn seal or packing
No or low
pressure (after
Worn or obstructed valves.
period of
Worn unloader piston.
normal use)
Worn E-Z start valve.
Water leaking
Worn or broken o-ring.
at gun/wand
connection
Loose hose connection.
Water leaking
Loose connections.
at pump
Piston packings worn.
Worn or broken o-rings.
Pump head or tubes damaged
from freezing.
CAUSE
17- ENG
CORRECTION
See How to Use Wand paragraph
in the Operation Section.
Clean filter.
Insure end of chemical hose is
fully submerged into chemical.
Dilute chemical. Chemical should
be the same consistency as
water.
Lengthen water supply hose
instead of pressure hose.
Have parts cleaned or replaced
by AWSC.
Have replaced by AWSC.
Have replaced by AWSC.
Have replaced by AWSC.
Have replaced by AWSC.
Check and replace.
Tighten.
Tighten.
Have replaced by AWSC.
Have replaced by AWSC.
Have replaced by AWSC.
D25801
Publicité
