Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT:
WIRING
Never use wiring less than AWG #12 between the battery and refrigerator.
HARDWIRING
When hardwiring your refrigerator to a battery, make sure there is a 10 Amp fuse for
MT35F-U1D-P and MT45F-U1D-P inline on the positive wire.
BE SURE THE POWER SUPPLY POLARITY IS CORRECT
In the event that the green refrigerator light fails to glow, inspect the power source
for proper voltage and correct polarity. The inner contact point of the DC Cord /
Plug must be positive and the outer contact negative (ground).
REDUCE RADIO NOISE INTERFERENCE – CONNECT REFRIGERATOR DIRECTLY
TO THE BATTERY
Reducing radio noise interference can be accomplished by twisting the power supply
wires together, attaching them directly to the battery and adding a 10 Amp fuse for
MT35F-U1D-P and MT45F-U1D-P near the positive battery connection. Avoid
splicing other devices into this circuit as interference may occur.
BATTERY CHARGERS
Never hook the refrigerator directly to a battery charger. It must only be attached to
a battery.
OPERATING YOUR REFRIGERATOR USING A PORTABLE GENERATOR
The internal refrigerator power supply unit may be damaged if powered by older style
generators without automatic voltage regulation. The only acceptable generators to
use are those that are "inverter style" or those with over-voltage protection. Please
contact your ENGEL Dealer for additional instruction on safe use when powering
your refrigerator with a portable generator.
CAUTION : The use of an extension cord is not recommended.
BATTERY PROTECTION
This fridge is equipped with a battery monitor cutting the compressor in or out in
order to protect the battery. When the "MODE" button is pressed twice, the LED
display will be blinking the current battery monitor state "OFF" or "LO" or "HI"
（default OFF） .
The "SELECT" button during this mode will display the OFF→LO→HI change.
After pre-setting the battery monitor, the LED display will stop blinking （after a
few second） , indicating the temperature has been set （locked） . The value by each
setting is shown on the below table. The battery monitor is not a necessary feature
for the fridge to operate. It may be left in the off position at all time.
Battery monitor setting
Cut out Voltage
Cut in Voltage
Cut out Voltage
Cut in Voltage
All manuals and user guides at all-guides.com
OFF
12V
−
12V
−
24V
−
24V
−
4
LO
HI
10.5V
11.5V
11.5V
12.5V
21.0V
23.1V
23.1V
25.0V
Publicité
