Publicité
Les langues disponibles
Les langues disponibles
chArge BAttery
1
Slide the battery
5
into the battery base
12
of the charging station
its LED lights 11:
red
red, green flashes During charging
red flashes
AttAch BAttery
1
Slide the battery
5
caution! Only use the provided bat-
tery with the drill driver.
fIt BIt
1
Open the chuck
ring 2
into the chuck.
caution! Before changing bits, cen-
tre the rotation direction switch, in
order to lock the drill driver.
fIt DrILL
1
Open the chuck
ring 2
into the chuck and set the torque
to drill .
caution! Before changing drills,
centre the rotation direction switch,
in order to lock the drill driver.
rotAtIon DIrectIon
1
To drive in screws or drill, set the rota-
tion direction switch
caution! If the drill driver is not in
use, centre the rotation direction
switch, in order to lock the drill driver.
10
and check
Operating
Fully charged
into the drill driver.
until the bit fits
until the drill fits
ring 7
8
to
.
2
Once the battery
5
is fully charged, pull
it out of the battery base 12.
2
To release the battery 5, press the bat-
tery release
buttons 9
the drill driver.
2
Fit the bit into the
chuck 1
the chuck
ring 2
securely. Set the de-
sired torque at the torque ring 7.
Remove the bit by opening the chuck
ring 2.
2
Fit the drill into the
chuck 1
the chuck
ring 2
securely.
Remove the drill by opening the chuck
ring 2.
2
To loosen screws, set the rotation di-
rection switch
8
to
and pull it out of
and tighten
and tighten
.
EN
87
Publicité
