Husqvarna 215iHD55 Manuel D'utilisation page 13

Introduction
WARNING:
safety chapter before you use the product.
Battery
WARNING:
safety chapter before you use the battery.
Read and understand the operator's manual
for the battery and the battery charger.
LED indicator
4 LED lights are on
3 LED lights are on
2 LED lights are on
1 LED light is on
1 LED light flashes
To charge the battery
CAUTION:
Connect the battery charger
to a power outlet with the voltage and
frequency that is specified on the rating
plate.
1. Connect the power cord to the battery charger.
2. Connect the battery charger to a grounded power
outlet. The charging LED flashes one time. (Fig. 30)
(Fig. 31)
3. Connect the battery to the battery charger. The
charging LED comes on. Charge the battery for
maximum 24 hours. (Fig. 32) (Fig. 33)
4. Push the battery indictaor button. The battery is fully
charged when all the LED indicators come on.
5. Pull the power plug to disconnect thr battery charger
from the power outlet. Do not pull the power cord.
6. Remove the battery from the battery charger.
To do before you start the product
1. Examine the work area. Remove objects that can be
thrown out.
2. Examine the cutting attachment. Make sure that the
blades are sharp, and have no cracks and damages.
1980 - 002 - 15.11.2023
Operation
Read and understand the
Read and understand the
Battery status (state of charge)
BLi10
N/A
The battery is 76% - 100% charged.
The battery is 51% - 75% charged.
The battery is 26% - 50% charged.
The battery is 0% - 25% charged.
Keep the battery and the battery charger in the correct
ambient temperatures.
Ambient temperature
Operation of the battery 5 °C-40 °C / 41 °F-104 °F
Charging of the battery 5 °C-40 °C / 41 °F-104 °F
Battery status
The display shows the state of charge and if there are
problems with the battery.
(Fig. 29)
40-B70
The battery is 76% - 100% charg-
ed.
The battery is 51% - 75% charged.
The battery is 26% - 50% charged.
The battery is 6% - 25% charged.
The battery is 0% - 5% charged.
3. Make sure that the product works correctly. Examine
that all nuts and screws are tight.
4. Make sure that the handle and safety devices are
not damaged and are attached correctly. Do not
operate a product with missing parts or is changed
from its initial specification. Use protective gloves
when it is necessary.
5. Make sure that the covers are not damaged and are
attached correctly, before you operate the product.
To start the product
1. Push the start/stop button until the green LED comes
on. (Fig. 34)
2. Push the front handle trigger on the front handle.
(Fig. 35)
3. Push the power trigger. (Fig. 25)
To operate the product
1. Start near the ground and move the product up
along the hedge when you cut the sides. Make sure
that the body of the product does not touch the
hedge. (Fig. 36)
WARNING:
front of the cutting equipment does not
touch the ground.
Make sure that the
13