Toto LT650 Manuel D'installation page 4

Preparation
1. Refer to the rough-in guide for
location of mounting bracket
holes.
2. Use a pencil to mark the
location of the screw hole that
corresponds to the slotted hole
in the mounting bracket.
3. Drill pilot hole for wood screw.
4. Install the mounting plate
to the wall using the bottom
screw only.
Lavatory Installation
1. Place lavatory on bracket and
brace adequately so that the
lavatory can not tip over.
2. Check to make sure the
lavatory is installed at the
correct height and is level.
3. Mark the location of the
mounting holes in the lavatory.
4. To help recall the lavatory
position, trace a line along
the sides and top edge of the
lavatory.
5. Remove the lavatory from
bracket.
6. Drill the remaining holes for
the mounting bracket and
install (2) remaining screws.
INSTALLATION PROCEDURE
4
mark lavatory position on wall with a pencil.